After the first month with the SV-300 silencer, the perimeter noise dropped by 38 dB at the property line. The installation team coordinated the vent tie-in without shutting down the main line for more than four hours. The only hiccup was the delivery window — it arrived two days later than the initial estimate, but the commissioning went smoothly once on site.

Communication during the setup phase was clear, but the initial drawings omitted the anchor bolt pattern for the PA-200 panels. We had to request a revision, which added a week to the schedule. Once corrected, the panels fit the compressor room layout exactly, and the acoustic readings met the 45 dB target at 1 meter. I would recommend asking for a detailed mounting plan upfront.

This was our second project with Junglekaraoke — we specified the AE-100 absorbers for a new gas turbine foundation. The elastomeric pads reduced the transmitted vibration by 72% compared to the previous steel spring isolators. The technical data sheet matched the field measurements within 3 dB across the 63 Hz to 500 Hz band. Consistent performance across two different sites gives us confidence for future specs.

We used the PA-200 panels to enclose three reciprocating compressors. The modular design made it easy to work around existing piping. The only downside was the weight — each panel is about 45 kg, so we needed two people and a lift for the upper rows. The noise reduction inside the enclosure is noticeable; operators no longer need double hearing protection when walking past.

The SV-300 silencer helped us pass the nighttime noise ordinance inspection on the first attempt. The previous setup was 8 dB over the limit. The engineering report included third-party acoustic measurements and a clear compliance certificate. I appreciated that the documentation was ready in both Spanish and English, which saved us translation time for the regulatory submission.