Junglekaraoke

Rated by plant engineers across the region

Our SV-300 silencer series has been deployed in over 40 compressor stations in Argentina and Chile. Clients report an average noise reduction of 38 dB at the property line, measured during full-load venting cycles.

Third-party audits by Acústica Sur S.A. confirm compliance with ISO 1569 and local decree 351/79 for occupational exposure limits. The PA-200 panel system is now specified by three major EPC contractors for new gas plant projects.

What operators say about the retrofit

“We installed the AE-100 absorbers on four reciprocating compressor skids. Vibration amplitude dropped by 62 % within the first week. The maintenance team no longer needs ear protection inside the hall.” — Lucas Moya, Plant Manager, Compresores del Sur

“The PA-200 panels were delivered and mounted in three days. Our perimeter noise dropped from 87 dB to 51 dB. The municipal inspector signed off immediately.” — Ing. Maite Jaime Tercero, HSE Coordinator, Gasoductos Patagónicos

“We compared three suppliers before choosing Junglekaraoke. The technical documentation was precise, and the on-site support during commissioning was excellent.” — Sr. Anthony Botello Hijo, Project Engineer, Petroquímica Austral

Client feedback

What operators report after installation

“We installed the SV-300 on two 1500 HP compressors. The perimeter reading dropped from 89 dB to 52 dB at 50 meters. The silencer held up during a 12-hour continuous run at 220 °C without any structural fatigue.”

Venting silencer

“The PA-200 panels reduced reverberation inside our compressor hall by 38 % measured at 500 Hz. Installation took three days for a 240 m² enclosure. The only delay was aligning the support rails on an uneven floor.”

Rock wool panel

“We placed the AE-100 absorbers on the base frames of four reciprocating compressors. Vibration amplitude at 30 Hz dropped by 64 %. The elastomer pads showed no creep after six months of continuous operation.”

Elasto-polymeric absorber

“The SV-300 silencer met the local ordinance limit on the first test. We had to add a support bracket because the flange weight was higher than expected, but the acoustic performance was consistent across all vent cycles.”

Venting silencer

“We used the PA-200 panels to enclose a test bench for large fans. The sound level outside the enclosure went from 97 dB to 61 dB. The modular assembly allowed us to relocate two panels when we changed the bench layout.”

Rock wool panel

Why engineers choose our acoustic systems

Our approach is built on measurable attenuation data, not marketing claims. Every component is tested against real compressor-room conditions and international B2B noise standards.

Verified attenuation curves

Each silencer and panel ships with a third-party frequency graph showing insertion loss from 63 Hz to 8 kHz. You get the data, not a brochure promise.

Rock-wool density matched to source

We specify the exact density and thickness for your compressor model and room geometry. A 100 mm panel at 110 kg/m³ absorbs 0.92 at 1 kHz — no guesswork.

Elastomer formulation for structural paths

Our AE-100 series uses a proprietary polymer blend that damps vibrations from 5 Hz to 500 Hz. Installed under compressor skids, it cuts transmitted energy by 18 dB.

Field-tested by plant engineers

Over 40 installations in gas compression and petrochemical plants. Clients include engineering firms that require pre- and post-installation sound surveys.

Compliance without redesign

Our systems are designed to meet OSHA, ISO 3744, and local Argentine noise regulations out of the box. No need to rework ducting or structural supports.

Cookie settings

We use cookies to keep the site reliable, remember basic choices, and understand which pages are useful. You can accept, reject, or review the settings before continuing.